Caswell Electrocleaning Kit - 3 Gal

Caswell Electrocleaning Kit Electrocleaning is a highly effective and fast way of cleaning parts prior to plating. It will remove oils, rust, grease and even paint. The part to be cleaned is hung into the cleaning solution and then connected to the POSITIVE side of the power supply, becoming the Anode. The GP Plates (included) are connected to the negative side, becoming the cathode. DC current is then supplied to the system. Current rates are approx 10-15 Amps per Square Foot of part surface area. Cleaning will take between 30 seconds to two minutes. After cleaning, the part should be rinsed and given a waterbreak test to check for cleanliness before moving on to plating. Our 3 Gallon Electrocleaning Kit contains: 1 x 3.5 Gal Tank and Lid 2lb Electrocleaner (Makes 4 Gallons total - you will have extra) 2 x 12" x 12" GP Plates Copper Pipe for tank bar Copper Part Hanging Wire Power Connecting Leads, to connect the anode and cathodes to a power source. Note that the kit does not contain a DC power source. Please choose one based on the size of the parts you will be plating. For example: 5" x 5" Sheet of Steel = 50 sq in total, which is 0.35 sq ft. At 10 ASF, you would need 3.5 amps 12" x 12" Sheet Of Steel (about the largest you can clean with this kit) = 2 sq ft, which would need 20 amps.

• 1 x 3.5 Gal Tank and Lid
• 2lb Electrocleaner (Makes 4 Gallons total - you will have extra)
• 2 x 12" x 12" GP Plates
• Copper Pipe for tank bar
• Copper Part Hanging Wire